Crestron C2N-FT-TPS4-U Guide d'installation télécharger pdf (Page 18)

FlipTop Touchpanel Control Center Crestron C2N-FT-TPS4/TPS4-U

5. Turn the four #10 screws equally until they contact the underside of the

mounting surface.

NOTE: Do not over-tighten the #10 screws as this may damage the surface and/or

the unit.

Mounting Bracket Installation

NOTE: Be careful not to press any screen pushbuttons or hard keys while closing

the Flip Top, even though the screen is disabled when the Flip Top begins to close

and all pressed buttons are released.

Hardware Hookup

Refer to the following hookup diagram and, aside from attaching power last,

complete the connections in any order.

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the specifications table. Consideration

must be given if installed in a closed or multi-unit rack assembly, inside a closed

desk, or in a closed podium since the operating ambient temperature of these

environments may be greater than the room ambient. Contact with thermal insulating

materials should be avoided on all sides of the unit.

14 • FlipTop Touchpanel Control Center: C2N-FT-TPS4/TPS4-U Operations & Installation Guide - DOC. 6398

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Pas de commentaire

Crestron C2N-FT-TPS4-U Guide d'installation Page 18