Crestron C2N-FT-TPS4-U Guide d'installation télécharger pdf (Page 17)

Crestron C2N-FT-TPS4/TPS4-U FlipTop Touchpanel Control Center

Cutout Dimensions

TPS4 (4007478)

6.13 in

(15.56 cm)

7.25 in

(18.42 cm)

Max Radius

(0.125 in)

(0.32 cm)

NOTE: Before inserting the TPS4 in the mounting hole, ensure that all required

cables have been installed.

Mounting Parts Supplied with the TPS4

PART DESCRIPTION QUANTITY

Screw #6-32, Pan Head, Phillips 8

Screw #10, Pan Head, Phillips 4

Mounting Bracket 2

1. Install the eight supplied #6-32 screws, but do not tighten (four on the front

side and four on the rear side). These will be used to secure the front and

rear mounting brackets.

2. Position the TPS4 in the mounting hole. (Refer to the following graphic.)

Mounting Bracket Screw Locations

3. Install the four #10 screws in the mounting brackets (two screws per

bracket). Refer to the following diagram.

4. Slide the mounting brackets over the #6-32 screws and tighten the

#6-32 screws.

Operations & Installation Guide – DOC. 6398 FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U • 13

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

Crestron C2N-FT-TPS4-U Guide d'installation Page 17