Crestron C2N-SDC Guide d'installation télécharger pdf (Page 15)

Crestron C2N-SDC-DC Shade & Drape DC Motor Controller

NOTE: The UP ▲button applies +24 VDC to pin A (referenced to pin

B). The DOWN ▼ button applies +24 VDC to pin B (referenced to pin

A). If the shade does not go in the desired direction when the button is

pressed, reverse the polarity of the shade motor wires.

Installation

The C2N-SDC-DC may be mounted in a two-gang electrical box or a

4 x 4 inch (1900) electrical box. Ensure that you are using a box with

sufficient depth (minimum 1.5 inch) to accommodate the device.

Screws are included for both mounting locations.

Included Mounting Hardware

QUANTITY PART APPLICATION

4 06-32 x 3/8” Pan Head

Screw

Two-Gang Electrical Box

Mounting (not provided)

2 08-32 x 3/8” Pan Head

Screw

4 X 4 inch (1900)

Electrical Box Mounting

(not provided)

Tools Required:

• Phillips screwdriver

Two-Gang Box Mounting

When mounting in a two-gang electrical box, use the four 06-32 3/8” pan

head screws as shown in the following illustration.

Operations & Installation Guide - DOC. 6373 Shade & Drape DC Motor Controller: C2N-SDC-DC y

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Pas de commentaire

Crestron C2N-SDC Guide d'installation Page 15