Crestron C2N-SDC Guide d'installation télécharger pdf (Page 14)

Shade & Drape DC Motor Controller Crestron C2N-SDC-DC

Hardware Hookup

Refer to the following hookup diagram. The C2N-SDC-DC is equipped

with three connector plugs that have screw terminals. Use these

connectors to attach the motor wires and Cresnet wires to the

C2N-SDC-DC.

NOTE: All wiring must be installed in accordance with all local and

national electrical codes.

NOTE: Three Watts are consumed by the C2N-SDC-DC when the

motors are not operating. Motor loads may be connected to the

C2N-SDC-DC up to the available power remaining on the Crestron

power supply. Crestron recommends an independent power supply for

each C2N-SDC-DC.

Hookup Diagram

y Shade & Drape DC Motor Controller: C2N-SDC-DC Operations & Installation Guide - DOC. 6373

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Pas de commentaire

Crestron C2N-SDC Guide d'installation Page 14