Crestron C2N-HBLOCK Guide d'installation télécharger pdf (Page 9)

Crestron C2N-HBLOCK Multi-Type Network Distribution Block

anything other than dimly illuminated, refer to “Y and Z LED

Illumination” on page 9 for further information.

Industry Compliance

As of the date of manufacture, the C2N-HBLOCK has been tested and

found to comply with specifications for CE marking and standards per

EMC and Radiocommunications Compliance Labelling (N11785).

Installation and Wiring

Installation

The C2N-HBLOCK may be installed into any convenient location by

securing the unit’s mounting plate with screws (not supplied) or into a

19-inch rack by using a CNXRMAK, Crestron Rack Mount Kit (not

supplied). To install the C2N-HBLOCK via the mounting plate or into a

rack, refer to the appropriate subsection.

Mounting Plate Installation

To install the C2N-HBLOCK via the mounting plate, attach the mounting

plate to a convenient location and anchor the unit with a screw through at

least one hole in each corner (mounting screws are not supplied). It is

recommended to install the C2N-HBLOCK in an area where the

connectors are accessible and LEDs are visible.

Rack Installation

The C2N-HBLOCK may also be installed into a rack by using a

CNXRMAK (not supplied). Perform the following steps to install the

C2N-HBLOCK into a rack. The only tool required for this procedure is a

#2 Phillips screwdriver.

1. Using a #2 Phillips screwdriver, remove the four mounting

screws (shown below) that secure the mounting plate to the

C2N-HBLOCK and remove the plate.

Operations & Installation Guide – DOC. 8157A Multi-Type Network Distribution Block • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Crestron C2N-HBLOCK Guide d'installation Page 9