Crestron CNX-PVID8x4 Spécifications télécharger pdf (Page 14)

Professional Video Distribution Switch Crestron CNX-PVID8x4

10 • Professional Video Distribution Switch: CNX-PVID8x4 Operations Guide - DOC. 8166A

6. Click Set ID to initiate the change. This will display the "ID command

has been sent" window.

7. In the "Command Complete" window, click OK.

8. In the Current Network Devices text window, verify the new Net ID

code.

9. In the "Set Network ID" window, click Close.

NOTE: The new Net ID code may also be verified by selecting Diagnostic | Report

Network Devices in the Viewport (alternately, select F4).

10. Repeat this procedure for each CNX-PVID8x4 to be added to the

system.

Cabling and Jumpers

Out of the box, the CNX-PVID8x4 provides four 16x8 crosspoint boards that can be

operated independently or in parallel. However, versatility was built into the unit.

Depending on how the four boards are cabled and/or jumpered, the unit can be used

in different hardware configurations. For example, cabling boards 1 and 3

conceptually eliminates level 3 (thus component sources are not allowed with this

configuration) and extends level 1 with 16 composite-only connections. Furthermore,

installation of the cable assembly and removal of jumpers splits level 3 (thus

component sources are restricted to inputs 9 through 16) and extends level 1 with

eight composite-only connections.

NOTE: Possible configurations and their respective applications when the

CNX-PVID8x4 is connected to Crestron Room Solution Boxes are summarized in

"Hardware Configurations" on page 14. Furthermore, cabling and jumper removal

may prove useful in systems where the CNX-PVID8x4 does not connect to a

Crestron Room Solution Box.

If the out-of-the-box configuration is desired, the following procedure, which defines

how to install the cable and remove jumpers, need not be completed. If one of the

other configurations is required, the only tools needed to complete this procedure are

a #2 Phillips screwdriver and a grounding strap (grounded workstation).

CAUTION: The CNX-PVID8x4 contains ESD sensitive devices. Perform the

following procedure while wearing a grounding strap that is properly grounded or on

a grounded workstation to avoid damaging the unit.

NOTE: This procedure assumes that the CNX-PVID8x4 does not have rack ears

attached and has yet to be connected to the network.

1. Place the CNX-PVID8x4 right side up on a flat surface.

2. Using a #2 Phillips screwdriver, remove the 16 cover screws from the

top (four screws) and sides (six per side) of the CNX-PVID8x4.

3. Lift and remove the CNX-PVID8x4 top cover.

4. Use the supplied cable (15863) to connect board 1 (bottom board) to

board 3, as shown in the following diagram.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Pas de commentaire

Crestron CNX-PVID8x4 Spécifications Page 14