Crestron HD-SCALER Guide d'installation télécharger pdf (Page 31)

Crestron HD-SCALER High-Definition Video Scaler

Operations & Installation Guide – DOC. 7136B High-Definition Video Scaler: HD-SCALER

•

Configuring Output Parameters

To configure output parameters, navigate to the Output main menu item and then

press OK on the IR remote.

The Output submenu appears as shown below.

Output Submenu

The Output submenu allows configuration of the following parameters:

• Resolution: Sets the video output resolution.

NOTE: When Resolution is set to Automatic (default setting), the preferred

resolution of the display is used. (Selecting EDID Video Info in the Output

submenu indicates the preferred resolution of the display.)

NOTE: To select a resolution, navigate to the desired resolution and then

press OK on the IR remote. The display shows the selected resolution and

provides a prompt asking whether the resolution is to be kept. Within 15

seconds, select Ok to keep the resolution or Revert to go back to the

previous resolution and then press OK on the IR remote. If OK is not

pressed within 15 seconds or if a resolution that is not supported by the

display is selected, the output reverts to the previous resolution. Depending

on the display, an error may be indicated prior to reverting to the previous

resolution.

NOTE: If the input resolution is 1080p24 and the output resolution is set to

1080p60, turning on the OSD causes the video to blank. The blanking of the

video is the expected behavior.

• Underscan: Sets underscan to None (default), 2.5%, 5.0%, or 7.5%.

In addition, the Output submenu also allows display of test patterns and provides

display of EDID video and audio information as well as video and audio output

signal information.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Crestron HD-SCALER Guide d'installation Page 31