Crestron CHV-RSS Guide d'installation télécharger pdf (Page 8)

Remote Slab & Outdoor Temperature Sensor Crestron CHV-RSS

•

Remote Slab/Outdoor Temperature Sensor: CHV-RSS Installation Guide – DOC. 6229D

Setup

Tile or Wood Floor Installation

Crestron recommends the sensor be placed inside a 1/2 inch (13 mm)

Electrical Metallic Tubing (EMT) conduit. This allows future sensor

replacement, if required. The radius of the bend at the wall should be

approximately 8 inches (203 mm), to allow for removal and replacement

of the sensor.

Sensor Position (Side View)

Conduit

Sensor

Radius

NOTE: Ensure the sensor conduit is vertically centered in the slab below

the surface.

Sensor Conduit Position in Slab

For indoor installations, consider the following:

• In small rooms, position the sensor near the center of the floor.

• In larger rooms, ensure the sensor is at least 6 feet (1.8 meters)

from the wall.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Crestron CHV-RSS Guide d'installation Page 8