Crestron CHV-RSS Guide d'installation télécharger pdf (Page 10)

Remote Slab & Outdoor Temperature Sensor Crestron CHV-RSS

•

Remote Slab/Outdoor Temperature Sensor: CHV-RSS Installation Guide – DOC. 6229D

NOTE: In tile floors, ensure a channel is made in the thin-set mortar, just

above the subflooring, to properly position the sensor.

Outdoor Installation

Required Materials (not supplied):

• Two wood screw coaxial cable standoffs with insulators

• One plastic feedthrough bushing

• Silicon adhesive

NOTE: Mount in a location away from direct sunlight.

NOTE: Sensor should not come in contact with metal objects.

Complete the following procedure to install the CHV-RSS:

1. Mount the sensor using two coaxial cable standoffs. If the fit is not

snug, use silicon adhesive to secure the sensor in place.

2. Use a plastic feedthrough bushing and pass the wires through the

outside wall.

3. Form a drip loop in the wire to prevent moisture from entering the

building.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Pas de commentaire

Crestron CHV-RSS Guide d'installation Page 10