Crestron CNRACKX-DP Spécifications télécharger pdf (Page 7)

Crestron CNXENET+ CNX Enhanced Ethernet Expansion Card

Installation

Installation into CNMSX-AV/PRO

Items 1 through 9 listed below for the installation of the CNXENET+ are either

attached to the card or already reside on the control system. The tools required are a

grounding strap, a #1 Phillips tip screwdriver, and a #2 Phillips tip screwdriver.

Follow the assembly procedure after this paragraph.

Referenced Items for CNMSX Installation

ITEM DESCRIPTION PART NUMBER QUANTITY

Screw, 6-32 x 1/4"L, steel,

flat, phillips, undercut, black

SR06-32-0R2500-8

Screw, 6-32 x 3/8"L, steel,

flat, phillips, undercut, black

SR06-32-0R3750-9

3 Control System Top Cover MTCV02376-1 1

Screw, 6-32 x 1/4"L, zinc,

pan, phillips, black

SR06-32-0R2500-2

5 I/O Printed Circuit Board PA05632-1 1

Screw, 4-40 x 3/8"L, steel,

pan, phillips, black

SR04-40-0R3750-3

Washer, lock, steel, internal

tooth, #4, zinc

WA04LO-1

8 Plate, blank, metal, LAN/DPA MTPL02390-1 1

9 CNXENET+ ZA11281 1

CAUTION: The CNXENET+ and the control system contain electro-static

discharge (ESD) sensitive devices. Perform the following procedure while wearing a

grounding strap that is properly grounded or on a grounded work station to avoid

damaging the card and/or the control system.

CAUTION: Refer to the latest revision of the CNMSX Operations Guide (Doc.

8118) for proper turn-off and, if applicable, removal procedures. The latest software

version can be obtained from the Products page (PRODUCT MANUALS, Hardware

section) or Downloads page (MANUAL Library) of Crestron’s website

(www.crestron.com). New users are required to register in order to obtain access to

the FTP site.

NOTE: The unit shown in this procedure is a CNMSX-AV. The procedure is

identical for the CNMSX-PRO.

NOTE: It is assumed that the control system rack ear brackets are not attached

during this installation procedure.

1. As shown on the next page, place the control system right-side-up on a

flat surface and using a #2 Phillips tip screwdriver, remove four screws

from the top of the unit.

Operations & Installation Guide – DOC. 8153A CNX Enhanced Ethernet Expansion Card: CNXENET+ • 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Crestron CNRACKX-DP Spécifications Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Crestron CNRACKX-DP