Crestron CNRACKX-DP Spécifications télécharger pdf (Page 20)

CNX Enhanced Ethernet Expansion Card Crestron CNXENET+

Communicating With the Control System via

Ethernet

The Crestron Viewport may be used to communicate with the control system via

Ethernet. To connect the Viewport to the control system, perform the procedure

below.

1. In the Viewport, select Remote

| TCP/IP | Connect as shown below.

Viewport Connect TCP/IP

2. As shown below, enter the IP address of the configured control system

and select the Connect

button. (Within the address, X and Y may range

from 0 to 255. In the example shown below, X is 135 and Y is 246.)

Connect TCP/IP Address Dialog Box

3. If a password has been set for the control system, an access password is

required to connect. As shown on the next page, enter the required

password. (The correct password must be entered within three attempts

or the password dialog box displays a password invalid message.)

16 • CNX Enhanced Ethernet Expansion Card: CNXENET+ Operations & Installation Guide – DOC. 8153A

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Crestron CNRACKX-DP Spécifications Page 20