Crestron ST-1700C Spécifications télécharger pdf (Page 24)

1-Way Wireless RF Touchpanel Crestron ST-1700C

C2Net Device, Slot 9

Double-click the CNRFGWA icon in the upper pane to open the “Device Settings”

window. This window displays CNRFGWA device information. Select the Net ID tab

to change the gateway Net ID, as shown in the following figure.

“Device Settings” Window for the CNRFGWA

NOTE: Recall that if the CNRFGWA is part of an ST-CP configuration, its NET ID is

fixed at 02 and cannot be changed.

Similarly, expand the system tree in the lower pane and double-click the ST-1700C

icon to open the “Device Settings” window for the touchpanel. Select the RF/IR ID tab

to change the touchpanel RF ID, as shown in the following figure. For more

information on setting the RF/IR ID, see “Select Interface on page 8.

NOTE: The hardware and software settings of the RF ID must match. Although the

device setting window in SIMPL Windows allows choices through the range of two-

digit Hexadecimal numbers from 01 through FE, the RF ID setting for the hardware is

limited to numbers in increments of the most significant digit (i.e., 00, 10, 20). Since

00 is not a valid selection in SIMPL Windows, the RF ID number is limited to the

fifteen numbers 10, 20, 30, 40, . . .F0.

20 • 1-Way Wireless RF Touchpanel: ST-1700C Operations Guide – DOC. 6050

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

Crestron ST-1700C Spécifications Page 24