Crestron DM-RMC-200-C Guide d'installation télécharger pdf (Page 23)

Crestron DM-RMC-200-C DigitalMedia 8G+™ Receiver 200

Setup

Network Wiring

When wiring the DM network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

CAUTION: Failure to use Crestron power supplies could cause equipment

damage or void the Crestron warranty.

• Provide sufficient power to the system.

• For DM 8G+ wiring up to 330 feet (100 meters) between devices, use

Crestron DM-CBL-8G DigitalMedia 8G cable, Crestron DM-CBL

DigitalMedia cable, Crestron DM-CBL-D DigitalMedia D cable, or generic

CAT5e (or better) UTP or STP. Shielded cable and connectors are

recommended to safeguard against unpredictable environmental electrical

noise which may impact performance at resolutions above 1080p. Refer to

the latest version of the Crestron DigitalMedia Infrastructure Guide (Doc.

4556) for complete wiring guidelines and to the Crestron DigitalMedia

Design Guide (Doc. 4789) for complete system design guidelines. The

manuals are available from the Crestron Web site at

www.crestron.com/dmresources.

The DM-RMC-200-C also uses high-speed Ethernet for communications between

the device and a control system, computer, media server, and other IP-based devices.

For general information on connecting Ethernet devices in a Crestron system, refer to

the latest version of the Crestron e-Control

Reference Guide (Doc. 6052), which is

available from the Crestron Web site (www.crestron.com/manuals). For information

specifically related to Ethernet connectivity using DigitalMedia devices, refer to the

latest version of the Crestron IP Considerations Guide for the IT Professional (Doc.

4579), which is also available from the Crestron Web site

(

www.crestron.com/dmresources).

Identity Code

NOTE: In the SIMPL Windows program, the IP ID of the DM-RMC-200-C is

assigned automatically and does not require additional programming when the

DM-RMC-200-C is dropped onto an output card of a DM switcher. Use the

information below when the DM-RMC-200-C is dropped directly into an Ethernet

slot on the control system in SIMPL Windows without a DM switcher.

The IP ID is set within the DM-RMC-200-C IP table using Crestron Toolbox™.

For information on setting an IP table, refer to the Crestron Toolbox help file.

The IP IDs of multiple DM-RMC-200-C devices in the same system must be unique.

When setting the IP ID, consider the following:

• The IP ID of each unit must match an IP ID specified in the SIMPL

Windows program.

• Each device using IP to communicate with a control system must have a

unique IP ID.

Operations & Installation Guide – DOC. 7126B DigitalMedia 8G+™ Receiver 200: DM-RMC-200-C • 17

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Crestron DM-RMC-200-C Guide d'installation Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur Crestron DM-RMC-200-C