Crestron SP-1 Manuel d'utilisateur télécharger pdf (Page 7)

CRESTRON

Operations Guide - DOC. 5729 Slide Controller: SP-SC •• 3

Setup

SP-SC with SmartPresenter™

Connect the 3.5 mm, Serial Data Cable (supplied) to the input port on the SP-SC.

Connect the other end of the cable to one of the outputs on the SP-1. The EBY, five-

pin, pickle type connector should be plugged into the projector.

To assign a Q-Code for the Slide Controller, refer to the latest revision of the

SmartPresenter – Quick Guide (DOC. 5742).

NOTE: An external power supply is not necessary when using the SP-SC with the

SmartPresenter system.

Connect Serial Data Cable to SP-1

Serial Data Cable

To Slide Projector

Serial Data Cable

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Crestron SP-1 Manuel d'utilisateur Page 7