Crestron DM-RX1-1G Guide d'installation télécharger pdf (Page 20)

DigitalMedia™ CAT Receiver Crestron DM-RX1-1G

NOTE: Braid should wind neatly around foil shield. Loose braid

may cause shorts.

“D” Cable (Wrapping the Twisted Braid)

Braid Wrapped

Around Foil Shield

7. Strip the insulation from the ends of each wire, exposing

approximately 3/16 inch (5 mm) of bare copper.

NOTE: Do not allow the twisted pairs to untwist for more than 1/2

inch (13 mm).

NOTE: Maintain equal wire lengths within 1/8 inch (3 mm).

8. Using an adjustable wrench, clamp the prepared cable to the unit

as shown in the following illustration.

NOTE: Twisted braid and foil shield must be in full contact with

inside of clamp.

16 • DM

CAT Receiver: DM-RX1-1G Operations & Installation Guide – DOC. 6969B

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Pas de commentaire

Crestron DM-RX1-1G Guide d'installation Page 20