Crestron CP2 Manuel d'utilisateur télécharger pdf (Page 12)

3-Card Expansion Cage for AV2 Crestron CAGE2

10. Refer to the diagram below. Re-install the the four rear-mounting SEM

(attached washer) screws that were removed in step 4 to finger-tight

then, using a #2 Phillips tip screwdriver tighten the screws an

additional 1/8-turn

CAGE2 Installation (9 of 11) - Re-install Rear-Mounting Screws

11. Position cover onto the AV2.

NOTE: The AV2 cover side screws are 0.375 in long and the cover top screws are

0.250 in long. Make sure that the correct screws are re-installed in the cover side and

top, respectively.

12. Refer to the diagram below. Re-install the six cover screws that were

removed from each side of the AV2 in step 2 to finger-tight

then,

using a #2 Phillips tip screwdriver tighten the screws an additional

1/8-turn

CAGE2 Installation (10 of 11) - Re-install Cover Side Screws

13. Refer to the diagram on the next page. Re-install the four

cover screws

that were removed from the top of the AV2 in step 1 to finger-tight

then, using a #2 Phillips tip screwdriver tighten the screws an

additional 1/8-turn

8 • 3-Card Expansion Cage for AV2: CAGE2 Installation Guide - DOC. 5964

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Crestron CP2 Manuel d'utilisateur Page 12