Crestron QMI-FTMC Guide d'installation télécharger pdf (Page 31)

Crestron QM-FTMC FlipTop Media Center

• Additional QM-FTMC devices are assigned different Net ID numbers as

they are added.

• If necessary, double click a device to open the “Device Settings” window

and change the Net ID, as shown in the following figure.

“QM-FTMC Device Settings” Window

• The ID code specified in the SIMPL Windows program must match the Net

ID of each unit. Refer to “Identity Code” on page 17.

Program Manager

Program Manager is the view where programmers “program” a Crestron control

system by assigning signals to symbols.

The symbol can be viewed by double clicking on the icon or dragging it into Detail

View. Each signal in the symbol is described in the SIMPL Windows help file (F1).

The buttons module is built into slot 03 of the QM-FTMC (refer to “C2Net Device,

Slot 9” on page 26). It consists of a keypad that provides 10 to 20 buttons with LED

indicators, and two bargraphs. The button presses are fixed and map to <press>

outputs on the symbol detail, as follows:

Row 1

Row 2

Row 3

Row 4

PWR

NET

12 345

678910

11 12 13 14 15

16 17 18 19 20

NOTE: Numbers in this illustration are for programming purposes only.

NOTE: Not applicable to NB models.

The buttons on rows 1 and 2 can be combined vertically to form one larger button.

For example, the button caps for buttons #1 and #6 can be replaced with one larger

button cap. Similarly, the vertical pairs on rows 3 and 4 can be combined to form one

larger button. For example, buttons #13 and #18 can be combined. No other

combinations are valid. That is, two buttons cannot be combined horizontally; the

buttons on rows 2 and 3 cannot be combined.

Operations & Installation Guide – DOC. 6311B FlipTop Media Center: QM-FTMC • 27

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 47 48

Pas de commentaire

Crestron QMI-FTMC Guide d'installation Page 31