Crestron C2N-FTB Guide d'installation télécharger pdf (Page 18)

FlipTop Control Center, Dual AC Outlets Crestron C2N-FTB-D

Mounting Bracket Screw Locations

3. Install the four #10 screws in the mounting brackets (two screws per

bracket). Refer to the following diagram.

4. Slide the mounting brackets over the #6-32 screws and tighten all eight

#6-32 screws.

5. Turn the four #10 screws equally until they contact the underside of the

mounting surface.

NOTE: Do not over-tighten the #10 screws as this may damage the surface and/or

the unit.

Mounting Bracket Installation

14 • FlipTop Control Center, Dual AC Outlets: C2N-FTB-D Operations & Installation Guide – DOC. 6639B

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Pas de commentaire

Crestron C2N-FTB Guide d'installation Page 18