Crestron C2N-FTB Guide d'installation télécharger pdf (Page 13)

Crestron C2N-FTB-D FlipTop Control Center, Dual AC Outlets

Setup

Network Wiring

When wiring the Cresnet

network, consider the following:

• Use Crestron Certified Wire.

• Use Crestron power supplies for Crestron equipment.

• Provide sufficient power to the system.

CAUTION: Insufficient power can lead to unpredictable results or damage

to the equipment. Please use the Crestron Power Calculator to help calculate

how much power is needed for the system (www.crestron.com/calculators

• For larger networks, use a Cresnet Hub/Repeater (CNXHUB) to maintain

signal quality.

For more details, refer to “Check Network Wiring” on page 22.

Identity Code

The Net ID of the C2N-FTB-D has been factory set to 1E. The Net IDs of multiple

C2N-FTB-D devices in the same system must be unique. Net IDs are changed from a

personal computer (PC) via the Crestron Toolbox™ (refer to “Establishing

Communication” on page 20).

When setting the Net ID, consider the following:

• The Net ID of each unit must match an ID code specified in the SIMPL™

Windows

program.

• Each network device must have a unique Net ID.

For more details, refer to the Crestron Toolbox help file.

Installation

NOTE: To prevent overheating, do not operate this product in an area that exceeds

the environmental temperature range listed in the table of specifications.

Consideration must be given if installed in a closed or multi-unit rack assembly,

inside a closed desk or in a closed podium since the operating ambient temperature

of the environment may be greater than the room ambient temperature. Contact with

thermal insulating materials should be avoided on all sides of the unit.

Operations & Installation Guide – DOC. 6639B FlipTop Control Center, Dual AC Outlets: C2N-FTB-D • 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

Crestron C2N-FTB Guide d'installation Page 13