Crestron TPS-ENET Guide d'installation télécharger pdf (Page 11)

Crestron TPS-ENET Ethernet Card for TPS/Tilt Panel

7. Place the touchpanel upright on the work surface.

8. As shown on the below, remove the touchpanel base cover by

raising it upwards and rearward.

Remove Touchpanel Base Cover

9. As shown on next page, align the pins on the touchpanel

interface connector of the TPS-ENET with the touchpanel

motherboard connector. DO NOT force pins into connector.

Press TPS-ENET until pins are fully seated. Make sure that

the screw holes of the card align with the mounting posts on

the motherboard.

Operations & Installation Guide - DOC. 6016 Ethernet Card for TPS/Tilt Panel: TPS-ENET • 7

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Crestron TPS-ENET Guide d'installation Page 11