Crestron C2N-IRGW-1G Guide d'installation télécharger pdf (Page 12)

IR Gateway Crestron C2N-IRGW-1G & C2N-IRGW-F

Installing a C2N-IRGW-1G

The following tools/hardware are required for installation of a C2N-IRGW-1G.

• Cresnet network cable (not supplied)

• Cresnet connector (supplied)

• Screwdriver (not supplied)

• Two ¾ in. combo head screws (supplied)

• Faceplate (not supplied)

• Standard single-gang electrical box (not supplied)

After the Cresnet network wiring has been installed and verified, use the following

procedure to install the C2N-IRGW-1G in a standard, single-gang electrical box

(refer to illustration that follows this paragraph):

1. Turn Cresnet system power OFF.

2. Connect the Cresnet cable with the supplied connector plug to the

C2N-IRGW-1G’s Cresnet port and the other end to the control system.

C2N-IRGW-1G Installation view

6-32 x ¾ in. combo head

Single-gang electrical box (not supplied)

CAUTION: Excess wire that is pinched between the C2N-IRGW-1G and the

electrical box could short out. Make sure that all excess wire is completely inside the

electrical box and not between the box and the C2N-IRGW-1G.

8 • IR Gateway: C2N-IRGW-1G & C2N-IRGW-F Operations & Installation Guide – DOC. 6468A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Pas de commentaire

Crestron C2N-IRGW-1G Guide d'installation Page 12