Crestron C2N-ANLZ Spécifications télécharger pdf (Page 12)

Cresnet

Analyzer Crestron C2N-ANLZ

Memory Card

When installing the memory card, observe the following:

• Insert the memory card with electrical contacts facing up.

• Push in the memory card until it clicks into the socket.

• The memory card should only be inserted or removed when the LOG LED

is off.

Battery

The C2N-ANLZ has a 9 Volt battery that is used as a backup in the absence of

Cresnet power. To install a battery, use a #2 Philips screwdriver and perform the

following:

• Remove memory card from C2N-ANLZ.

• Remove the four cover screws from the top of the C2N-ANLZ.

• Lift the top cover to expose the battery.

• Remove the old battery from the battery socket, if one exists.

• Install a fresh battery. Observe polarity.

• Replace and secure the top cover with the cover screws.

8 • Cresnet

Analyzer: C2N-ANLZ Operations Guide – DOC. 6473

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Crestron C2N-ANLZ Spécifications Page 12