Crestron CP2 Spécifications télécharger pdf (Page 24)

2-Series Integrated Control Processor Crestron CP2/CP2E

Module Header Information

After you convert each module in a program, you can convert the program as

described previously: drag the CP2 or CP2E onto the existing control system in

System Views and click Yes to confirm the replacement.

For further information about compile-time errors and detailed explanations about

working with modules, refer to the SIMPL Windows online help file.

Establishing Communication with the CP2/CP2E

Before uploading a program to the CP2/CP2E or performing diagnostic functions,

you must connect the control system to the PC. With the CP2, this connection must

be serial; with the CP2E the connection can be either serial or TCP/IP.

Serial Connection

Connect the COMPUTER port on the control system to one of the COM ports

(usually COM 1) on the PC. Use a straight-through RS-232 cable with a DB9 male

connector on one end and a DB9 female connector on the other. Most commercially

available cables are acceptable; they should have at least 5 pins for transmit, receive,

ground, and hardware handshaking.

Open the Crestron Viewport and click Setup | Communication Settings to display

the “Port Settings” dialog box. Then click RS-232 as the connection type.

The PC communication settings specified here should match the protocol that the

CP2/CP2E expects. The settings are as follows:

• Port = COM 1 through COM 8. Select the correct COM port on the PC.

• Baud rate = 115200 (You can set the PC and the control system to a

different baud rate, by using the Functions | Set Baud Rate command.

• Parity = None.

• Number of data bits = 8.

• Number of stop bits = 1.

20 • 2-Series Integrated Control Processor: CP2/CP2E Operations Guide - DOC. 5980

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Pas de commentaire

Crestron CP2 Spécifications Page 24