Crestron infiNET EX CEN-RFGWX-EX Guide d'installation télécharger pdf (Page 12)

InfiNET EX™ Gateway Crestron CEN-RFGW-EX

Connectors, Controls & Indicators (Continued)

# CONNECTORS

CONTROLS &

INDICATORS

DESCRIPTION

8 NET

GZ Y

(1) 3.5 mm detachable terminal

block;

Cresnet slave port, connects to

Cresnet control network

24: Power (24 Volts DC)

Y: Data

Z: Data

G: Ground

1. Interface connector for NET port is provided with the unit.

2. To determine which is pin 1 on the cable, hold the cable so that the end of the

eight pin modular jack is facing away from you, with the clip down and copper

side up. Pin 1 is on the far left.

3. Power should be supplied through either the LAN PoE port or the NET port but

not both.

4. The pin out table indicates signal connections. DC power applied by Ethernet

power sourcing equipment (PSE) can connect to either signal pins or N/C pins.

8 • infiNET EX™ Gateway: CEN-RFGW-EX Operations & Installation Guide – DOC. 6706A

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Pas de commentaire

Crestron infiNET EX CEN-RFGWX-EX Guide d'installation Page 12