Crestron QM-TX Spécifications télécharger pdf (Page 30)

QuickMedia™ Transmitter Crestron QM-TX

2. Open Installer’s Toolbox and click Tools | Manage Address Book to

display the communications settings. Enter the new address name, and

then click RS-232 as the connection type.

3. The PC communication settings specified here should match the

protocol that the control processor expects. The usual settings are as

follows:

• Port = COM 1 through COM 8. Select the correct COM port on the

PC.

• Baud rate = 115200.

• Parity = None.

• Number of data bits = 8.

• Number of stop bits = 1.

• Hardware handshaking (RTS/CTS) enabled.

• Software handshaking (XON/XOFF) not enabled.

“Address Book” Window – Serial Settings

4. After setting the correct parameters, click OK to return to the

Installer’s Toolbox main window.

5. Click Tools | Network Device Tree to display the devices in the

system.

TCPIP Connection

1. Ensure that all devices are connected to the control processor. For

TCP/IP, use CAT5 straight through cables with 8-pin RJ-45 connectors

to connect the LAN port on the control processor and the LAN port on

the PC to the Ethernet hub. Alternatively, you can use a CAT5

crossover cable to connect the two LAN ports directly, without using a

hub. The following table illustrates pinouts for straight through and

crossover RJ-45 cables. Pins 4, 5, 7, and 8 are not used.

26 • QuickMedia™ Transmitter: QM-TX Operations Guide - DOC. 6334

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Crestron QM-TX Spécifications Page 30