Crestron DM-RMC-200-S2 Guide d'installation télécharger pdf (Page 32)

DigitalMedia 8G Fiber Receiver 200 Crestron DM-RMC-200-S/S2

Uploading and Upgrading

Crestron recommends using the latest programming software and that each device

contains the latest firmware to take advantage of the most recently released features.

However, before attempting to upload or upgrade it is necessary to establish

communication. Once communication has been established, files (for example,

firmware) can be transferred to the device. In addition, the IP table of the device can

be configured.

Establishing Communication

Use Crestron Toolbox for communicating with the DM receiver; refer to the

Crestron Toolbox help file for details.

A PC running Crestron Toolbox communicates with the DM receiver in the

following ways:

 Via a DM switcher using TCP/IP or USB communication. TCP/IP provides

a faster method of communication than USB.

 Via the LAN port of the DM receiver using TCP/IP communication. In this

scenario, the DM receiver is used in a standalone configuration (i.e., a DM

switcher is not used).

Via DM Switcher

TCP/IP Communication via DM Switcher

To establish TCP/IP communication between the PC and the DM receiver via the

DM switcher:

1. Establish communication between the PC and the DM switcher as described

in the latest version of the DigitalMedia Switchers Operations Guide

(Doc. 6755).

2. Use the Device Discovery Tool in Crestron Toolbox to find the IP address

of the DM receiver. The tool is available in Toolbox version 1.15.143 or

later.

26  DigitalMedia 8G Fiber Receiver 200: DM-RMC-200-S/S2 Operations & Installation Guide – DOC. 7246B

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Pas de commentaire

Crestron DM-RMC-200-S2 Guide d'installation Page 32