Crestron DIN-PWS50 Manuel d'utilisateur télécharger pdf (Page 16)

DIN Rail Cresnet

Distribution Block Crestron DIN-BLOCK

•

DIN Rail Cresnet

Block: DIN-BLOCK Operations & Installation Guide – DOC. 6670B

DIN-BLOCK Data Signal LED Troubleshooting

Y Z DATA SIGNAL CONDITIONS

Bright Dim Both Y and Z data signals present

Off Bright Both data signals missing

Bright Bright Y data signal is present, Z is missing

Off Dim Z data signal is present, Y is missing

Dim Bright Y and Z data signals reversed

Check Network Wiring

Use the

Right Wire

In order to ensure optimum performance over the full range of the

installation topology, Crestron Certified Wire and only Crestron

Certified Wire may be used. Failure to do so may incur additional

charges if support is required to identify performance deficiencies

because of using improper wire.

Calculate

Power

CAUTION: Use only Crestron power supplies for Crestron equipment.

Failure to do so could cause equipment damage or void the Crestron

warranty.

CAUTION: Provide sufficient power to the system. Insufficient power

can lead to unpredictable results or damage to the equipment. Please use

the Crestron Power Calculator to help calculate how much power is

needed for the system (www.crestron.com/calculators

When calculating the length of wire for a particular Cresnet run, the wire

gauge and the Cresnet power usage of each network unit to be connected

must be taken into consideration. Use Crestron Certified Wire only. If

Cresnet units are to be daisy chained on the run, the Cresnet power

usage of each network unit to be daisy chained must be added together

to determine the Cresnet power usage of the entire chain. If the unit is

home-run from a Crestron system power supply network port, the

Cresnet power usage of that unit is the Cresnet power usage of the entire

run. The wire gauge and the Cresnet power usage of the run should be

used in the following equation to calculate the cable length value on the

equation’s left side.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Crestron DIN-PWS50 Manuel d'utilisateur Page 16