Crestron CP3 Spécifications télécharger pdf (Page 22)

3-Series Control System™ Crestron CP3

18  3 – Series Control System™: CP3 Operations Guide – DOC. 7316A

USB

NOTE: Required for initial setup of Ethernet parameters.

NOTE: Required for loading projects and firmware.

USB Communication

USB

PC Running

Crestron Toolbox

CP3

The COMPUTER port on the CP3 connects to the USB port on the PC via the

included Type A to Type B USB cable:

1. Use the Address Book in Crestron Toolbox to create an entry using the

expected communication protocol (USB). When multiple USB devices are

connected, identify the CP3 by entering “CP3” in the Model text box, the

unit’s serial number in the Serial text box or the unit’s hostname in the

Hostname text box. The hostname can be found in the “System Info”

window in the section marked Ethernet however, communications must be

established in order to see this information in the “System Info” window.

2. Display the CP3’s “System Info” window (click the

icon);

communications are confirmed when the device information is displayed.

TCP/IP

NOTE: Required for operation with a Crestron control system.

Ethernet Communication

PC Running

Crestron Toolbox

LAN

CP3

The CP3 connects to PC via Ethernet:

1. Establish serial or USB communication between CP3 and PC.

2. Enter the IP address, IP mask and default router of the CP3 via Crestron

Toolbox (Functions | Ethernet Addressing); otherwise enable DHCP.

NOTE: Use the Device Discovery Tool in Crestron Toolbox to detect all Ethernet

devices on the network and their IP configuration. The tool is available in Toolbox

version 1.15.143 or later.

3. Confirm Ethernet connection between CP3 and PC. If connecting through a

hub or router, use CAT5 straight through cables with 8-pin RJ-45

connectors. Alternatively, use a CAT5 crossover cable to connect the two

LAN ports directly without using a hub or router.

4. Use the Address Book in Crestron Toolbox to create an entry for the CP3

with the CP3’s TCP/IP communication parameters.

5. Display the “System Info” window (click the

icon) and select the CP3

entry.

6. Use Crestron Toolbox to create the CP3 IP table.

7. Select Functions | IP Table Setup.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Crestron CP3 Spécifications Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Crestron CP3