Crestron C2ENET-2 Guide d'installation télécharger pdf (Page 9)

Crestron C2ENET-1/-2 2-Series Ethernet Interface Expansion Cards

Setup

This section contains hardware installation and IP setup instructions for the

C2ENET-1/-2.

Required Tools/Hardware

#1 Phillips screwdriver

Grounding strap (recommended)

Straight-through RS 232 cable with a male DB9 connector and a female DB9

connector

PC with Viewport installed and open

Crestron Control System

Ethernet cable (straight thru or crossover)

Installation

CAUTION: The C2ENET-1/-2 and the control system contain electro-static

discharge (ESD) sensitive devices. Crestron recommends that you wear a grounding

strap to avoid damaging the card and/or the control system.

1. Disconnect power and Cresnet cables from the control system.

2. At the control system rear panel, remove the Z-BUS expansion slot blank

faceplate. Refer to the following three examples.

AV2 (AV2 with Card Cage & PRO2 Similar) Z-BUS Expansion Slot Example

S8 Z-BUS

PAC2 Z-BUS Expansion Slot Example

S3 Z-BUS

Operations & Installation Guide – DOC. 5962B 2-Series Ethernet Interface Expansion Cards: C2ENET-1 & C2ENET-2 • 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Crestron C2ENET-2 Guide d'installation Page 9